🩹 Slash Commands /l1-* Not Showing
/l1-*commands are regular files in your AI agent's folder. If they are missing from the/menu, the agent did not find them in the folder it reads.
Step 1. Update the files and open a new session
npx l1dder@latest updateThen start a new agent session or restart the agent: a session that is already open may not see new commands.
Step 2. Check that the command file exists
npx l1dder doctor does not check agent folders, so look at the file itself:
| Agent | File that should exist in your project |
|---|---|
| Claude Code | .claude/skills/l1-task/SKILL.md |
| Cursor | .agents/skills/l1-task/SKILL.md or .cursor/skills/l1-task/SKILL.md |
OpenAI Codex (commands are invoked as $l1-task) | .agents/skills/l1-task/SKILL.md |
| OpenCode | .agents/skills/l1-task/SKILL.md |
| Windsurf | .windsurf/workflows/l1-task.md |
| GitHub Copilot | .github/prompts/l1-task.prompt.md |
| Cline / Roo Code | There are no separate commands: L1DDER installs only rules for them. Write in chat: Follow l1dder/skills/l1-task/SKILL.md |
This check works in a macOS/Linux terminal and in PowerShell:
ls .claude/skills/l1-task/SKILL.mdStep 3. If the file is missing, add the agent
Most likely the agent was not selected during installation. List all the agents you use:
npx l1dder@latest sync --agents cursor,claude⚠️ Skill folders of agents missing from the list will be removed. The source folder
l1dder/skills/stays in place.
Then open a new agent session.
Still missing: common cases
Claude Code together with Codex or OpenCode, version 1.0.1 or older
These versions put skills only in .agents/skills/, while Claude Code reads only .claude/skills/. Update L1DDER with the command from Step 1: newer versions keep skills in both folders.
Cursor doesn't see the commands, and only claude is installed
Cursor reads .claude/skills/ only with the Third-Party Imports setting enabled (Cursor Settings → Agents). It is more reliable to add Cursor to the agent list as in Step 3: the commands will then be in a folder it always reads.
A teammate cloned the project and has no commands
The agent folders were not committed. Commit them, or ask your teammate to run npx l1dder sync after cloning.
Windows
No extra setup is needed: L1DDER installs commands as plain copies, so symlinks and Developer Mode are not required.
Didn't find your case? Open an issue on GitHub and mention your agent and L1DDER version.